Remove the model from the platform and soak it in the anhydrous ethanol cleaning container for 5 minutes. If the surface structure of the model is complex and difficult to clean, it can be cleaned by the low-frequency ultrasonic cleaner. If it is cleaned by the high-frequency and high-power ultrasonic cleaner, it may cause certain damage to the surface of the model, and also the details of the model may be damaged. Dry thoroughly with a hair dryer; The surface oil should be cleaned again until the surface of the model is dry.
Disposable rubber gloves.
the sandpapers of all kinds of granularity
Surface treatment after removal of supports:
Some methods of removing supports may cause the small pieces to be detached . Please beware of flying debris and consider wearing safety gloves and glasses to protect your skin and eyes.
Removing the support contacts will leave raised marks and cracks on the surface of the model .Please wear gloves to protect your skin from the resin dust caused by sanding. Start with the lowest /coarsest sandpaper (e.g. 150 mesh) and polish the surface of the model as needed. Gradually use the finest sandpaper to achieve a flat, polished and even surface. Please consider using 150 mesh, 220 mesh, 400 mesh, 800 mesh, 1000 mesh and 2000 mesh sandpaper successively, depending on the required smoothness, until the surface is smooth.
Warning：Please use general safety measures to sand the model with the sandpapers . Consider wetting the surface of the model to reduce dust.
Surface treatment with varnish
Sanding may leave a layer of dust on the surface of the print. Wipe the model with microfiber cloth and a little mineral oil to remove the cured resin dust.
Mineral oil makes the surface of the parts slightly shiny and moist, but too much oil can make the parts feel greasy when touched. To get a finer and better polished surface, please return to the sanding step and wet polish with a finer sandpaper. It can help to get a smooth surface.
Optional: spray primer, bead, lacquer or polish.